PoolLight Support
PoolLight controls a J&J ColorSplash XG pool light through a PoolLight controller on your home Wi-Fi.
Getting a controller
The PoolLight controller is open source. The parts list, wiring and firmware are in the PoolLight repository.
Setting up
- Power on the light controller. Its light flashes while it’s in setup mode.
- On your iPhone or iPad, open Settings › Wi-Fi and join LIGHT_SETUP.
- Open PoolLight. Choose your home Wi-Fi network, enter its password, and tap Connect.
- Rejoin your home Wi-Fi. PoolLight finds the controller automatically.
The app can’t find the light controller
Check the light on the controller:
- Flashing: it’s in setup mode. Join LIGHT_SETUP and follow the setup steps above.
- Off: it’s trying to join your Wi-Fi. If the password was wrong, it returns to setup mode within 2 minutes. If it stays off, hold its button for 10 seconds until the light flashes, then set it up again. If your router was just restarted, wait a few minutes first.
- Solid: it’s connected. Make sure your iPhone or iPad is on the same Wi-Fi network, then tap the refresh button in the top-right corner.
Still not found? In Settings › Privacy & Security › Local Network, make sure PoolLight is turned on.
Report a problem or ask a question at github.com/brianmichaellay/PoolLight/issues.
Privacy Policy